Maintenance And Maintenance Of Guide For Polystyrene Block Molding Machine

- Jun 27, 2017-

Maintenance and maintenance of guide for Polystyrene Block Molding Machine
Polystyrene block forming machine commonly used in the form of rectangular guide rails, biaxial core linear guide, cylindrical linear sliding unit, etc., using different types of rails on the polystyrene block machine tool mechanical precision have a certain impact. However, regardless of which type of guide rail, must be regularly on its maintenance, can effectively ensure the accuracy of the mechanical operation of equipment to extend the life of the rail.
In order to ensure the life of the rail system, regular maintenance is critical. The guide rail is one of the precision parts of the machine, it is impossible to 100% dust protection, dust pollution. Therefore, the user should regularly check, maintenance. Linear guide and linear roller guide column requires regular lubrication, a lot of linear guide system of steel ball and roller parts are equipped with grease connector and bracket connected. Regardless of the form of the rail system used to keep the rolling elements of good lubrication, can reduce the wear of the rail system to extend the machine to maintain the accuracy of time.
    How does polystyrene block machine operate? The following by Qingdao Shengtong to tell you about, Qingdao Shengtong has several decades of production technology experience, and is the largest in the laser molding machine manufacturers.
1, Polystyrene Block Molding Machine to confirm the device has a blade of the sliding plate in front of one end, open the size of the pressure plate;
2, with a stripper stripping fiber coating, reserved bare fiber length of 30-40mm, with alcohol dipped cotton or cotton paper wrapped in fiber, and then clean the fiber. Rub with cotton or cotton paper, do not use the same cotton or cotton paper to wipe the second time (Note: Please use more than 99% purity of alcohol).
3, visual fiber coating edge alignment cutter scale (12-20cm) the appropriate scale, the left hand into the guide groove into the fiber, requiring bare fiber straight on the left and right rubber pad.
4, Polystyrene Block Molding Machine close the small pressure plate, large pressure plate, push the device with a blade of the slider, so that the blade cut the lower surface of the fiber, and free to slide to the other side, cut off the fiber;
5, left hand hold the cutter, right hand to open the big pressure plate and remove the fiber debris, into a fixed container.
6, Polystyrene Block Molding Machine with his left hand to pinch the fiber while the right hand to open a small pressure plate, carefully remove the cut end of the fiber, Note: clean fiber section do not touch it.